gave my old mbc to a friend to fit on his manual T5 but can't remember which connection goes where
so 1st question is where does the bottom connection go to
and where does the side connection go to
next question may sound silly (and probably is) but does a dump valve have to be upright to work...........ie piston facing up
thanks in anticipation as always
will make it a lot easier to fit them in morning for him if we know where everything goes
my dump valve is on its side, so anyway should be fine. not a clue about the mbc
The outlet to the right of the picture goes to the actuator.
2nd shortest thread in history.... oops! 3rd now lol.
[QUOTE=M-R-P;654228]2nd shortest thread in history.... oops! 3rd now lol.[/QUOTE] Must be time to go off topic, just to bulk it out a bit.;)
[QUOTE=stribo;654236]Must be time to go off topic, just to bulk it out a bit.;)[/QUOTE] errrr ok... you bent a rod yet Steve?
......or fitted that intercooler ?
No, and no.
[QUOTE=M-R-P;654237]errrr ok... you bent a rod yet Steve?[/QUOTE] He will just give him time :)
A thread go off topic on VPC...? Never..
[QUOTE=oblark;654262]He will just give him time :)[/QUOTE] You're confusing me with someone else, I can resist the temptation to keep winding my bleed valve out to get more boost. :P
as usual thanks for the info..........................didn't think for a minute this would go off topic......................................
[QUOTE=stribo;654272]You're confusing me with someone else, I can resist the temptation to keep winding my bleed valve out to get more boost. :P[/QUOTE] Is it a bit "tappy" yet? ;)
[QUOTE=stribo;654272][COLOR="#FF0000"]You're confusing me with someone else[/COLOR], I can resist the temptation to keep winding my bleed valve out to get more boost. :P[/QUOTE] No, he doesn`t drive a gay gold C70 :)