Post 743252 by Sweep on 2014-10-18 15:50:57
Just fitted my blanking plate (what a £££££££ job), and now I'm wondering what to do with the vacuum hose that used to be on the valve itself? Can I use where it goes to the inlet for my boost gauge? Ben.
Just fitted my blanking plate (what a £££££££ job), and now I'm wondering what to do with the vacuum hose that used to be on the valve itself? Can I use where it goes to the inlet for my boost gauge? Ben.
You run the pipe to a dump valve unless you want to f££k your turbo up.
[QUOTE=oblark;743253]You run the pipe to a dump valve unless you want to f££k your turbo up.[/QUOTE] I'm aware of the potential risks of not running any form of recirc/dump valve, however the 15g simply doesn't make enough boost for compressor stall to be enough of an issue. Besides, if anything does occur, it'll give me the perfect excuse to go down the bigger turbo route :wink:
Block/seal the hole up.
[QUOTE=Saaamon;743268]Block/seal the hole up.[/QUOTE] Can the port on the inlet not be used for a boost gauge?
[QUOTE=Sweep;743270]Can the port on the inlet not be used for a boost gauge?[/QUOTE] yes :)
[QUOTE=oblark;743271]yes :)[/QUOTE] Marvelous! Another job on the list to do.