Post 77235 by Bigtony on 2006-02-02 13:48:08
:sinner: [FONT=Comic Sans MS]Hi I am about to rebuild 1 bore (No 5) on my 850 T5 any one got Ideas of where to get two inlet valves a con rod?[/FONT]
:sinner: [FONT=Comic Sans MS]Hi I am about to rebuild 1 bore (No 5) on my 850 T5 any one got Ideas of where to get two inlet valves a con rod?[/FONT]
theres a dead t5 engine on ebay at the minute for 45quid i think. worth it for the spare internals.
[QUOTE=bowman]theres a dead t5 engine on ebay at the minute for 45quid i think. worth it for the spare internals.[/QUOTE] I've got a dead T5 engine in my garage I keep meaning to strip! Must get round to it one of these days!
Sounds like I could strip it for you D5! but I see your in brighton I'm in brum bit of a Journey aint it!
Give Salvo a try mate. http://www.salvogroup.co.uk/salvosite.htm
i got some valves in an 850 2.0 20v head here dunnop if they the same though
[QUOTE=Bigtony]Sounds like I could strip it for you D5! but I see your in brighton I'm in brum bit of a Journey aint it![/QUOTE] Lol. I'll be stripping it in March/April I suspect!
i got a spare t5 head full of valves!!!!! no rods though